6
Binding/Unbinding control: By default the switch will automatically switch audio
control to the KVM port you select to control (bound). If you choose to “unbind”
control, you can assign control of the audio to a port other than the active computer
using the commands above.
Valid hotkey sequences: If you enter the “Dene new hotkey sequence” command
([ScrLk]+[ScrLk]+[H]+[y] the value of [y] replaces the [ScrLk]+[ScrLk] command with
one of the following:
[CapsLk] = [CapsLk]+[CapsLk]
[Esc] = [Esc]+[Esc] [F12] = [F12]+[F12]
[NumLk] = [NumLk]+[NumLk]
[ScrLk] = [ScrLk]+[ScrLk] (if another key sequence has been enabled)
Programmable Autoscan delay time: [z] can be any one of the following values:
1=10 sec., 2=20 sec. through 9=90 sec., 0=100 sec.
Note: Apple computers will need to be programmed using an IBM-compatible
keyboard that has a Scroll Lock key.
To Next Page
Loading...
