RESIDENTIAL
Complies with HUD Standards for Manufactured Housing
Installation. Design-Certified by CSA International -
Also complies with National Appliance Energy Conservation Act (NAECA)
energy-efficiency standards effective January 20, 2004.
Gas Control Is Convertible for Natural and Propane Gas -
For flexibility to meet the varying needs of Manufactured Housing installations.
Side-Mounted 3/4” Cold Water Inlet - For ease of installation
when cold water supply originates below the structure. Top-mounted 3/4" hot water outlet.
Direct-Vent Models Packaged with Bottom Intake Air Vent -
To draw all combustion make-up air from outside the structure.
Optional Ducted Air Inlet Kit for Direct-Vent Models - For use when
water heater is installed over a basement. Provision for horizontal air inlet ducting up
to 30 feet, using Schedule 40 PVC pipe. Kit includes 45° rodent-proof termination
cap and wall collars. Kit #9002986 for 30 and 40 gallon models. Kit #9002987 for
50-gallon models.
Approved Roof Jack Kits Required for Installation of
Direct-Vent Models -
Four kits available to accommodate vertical vent distances from 12" to 96"
(see back of sheet).
Green Choice™ Eco-Friendly Gas Burner - Patented design reduces NOx
emissions by up to 33% and complies with Southern California and Texas requirements.
Glass-Lined Tank - For long-lasting protection against rust and corrosion.
Anode Rod - Helps protect against rust and corrosion for long life.
Factory-Installed Temperature & Pressure (T&P) Relief Valve
Maximum Hydrostatic Working Pressure 150 PSI
1-Year or 6-Year Limited Tank Warranty
®
Standard-Vent and Direct-Vent Gas Water Heaters
MANUFACTURED
HOUSING
SCOUT
For more information on Scout® contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800-365-0024 Toll-free
www.statewaterheaters.com
SMGSS00108
192241_SMGSS00108.indd 1 2/27/08 4:24:14 PM
To Next Page
Need help?
General
