7
• Reconnect the disconnect wires to the
control panel and light connectors.
• Replace the metal lter by putting in one side rst then the
other side can be gently pushed in.
• The air outlet pipe can now be connected to the
appliance and feed through the pre-drilled outlet hole
Important: Ensure the exhaust hole is not bent more than 90°
as this may aect the performance of the appliance.
OPERATING INSTRUCTIONS
Switching on the Appliance
• Plug the appliance into the mains supply.
• Press the button to select the required function;
- = O
- = Low Speed
- = Medium Speed
- = High Speed
- = Light
Important: It is recommended when frying or cooking foods with strong aromas to select the
highest speed.
Replacing the Bulb
Before maintenance ensure the appliance is disconnected
from the mains electricity supply.
• Remove the Filter from the appliance by
pressing the lock catch.
• Push out the bulb from
inside the appliance.
• Disconnect the wires to the old bulb
and reconnect the new bulb.
• Push the new bulb in to the available hole
from the outside of the appliance.
To Next Page
Loading...
