To Next PageTo Next Page
Need help?Do you have a question about the Staubli MC4-Evo 2 and is the answer not in the manual?
General| Pollution Degree | 3 |
|---|---|
| Contact Material | Copper alloy |
| Degree of Protection | IP68 |
| IP Rating | IP68 |
| Cable Cross-Section | 6 mm² |
| Approvals | TUV, UL |
| Compatibility | MC4 |
| Temperature Range | -40°C to +90°C |
| Contact Plating | Sn |
Emphasizes the critical consequences of not following safety and assembly procedures.
Specifies that only electricians or electrically instructed persons should perform installation.
Describes the function of in-line fuses to interrupt DC circuits during over-currents.
States to never use damaged connectors and only use approved tools and procedures.
Highlights that live parts can remain energized and installation requires de-energized arrays.
Details procedures for de-energizing the system before mating/disconnecting and avoiding under-load operations.
Strictly prohibits modifying or attempting to repair components; defective parts must be replaced.
Identifies the product as PV-K/1500ILF36E.
Covers voltage rating, test voltage, safety class, overvoltage category, and pollution degree.
Includes temperature limits, ambient temperature range, IP rating, and insulation material.
Details compatible connectors and rated current (gPV) values.
Lists certifications like TÜV Rheinland and standards like IEC60269-6.
Describes the specific assembly and unlocking tool (PV-MS-PLS) for MC4-Evo 2 connectors.
Warns against disconnecting or connecting the fuse in an energized electrical circuit.
Details using the disconnect tool to separate connectors before inserting the in-line fuse.
Covers protecting unmated connectors, avoiding contaminated connectors, and chemical contact.
Specifies minimum cable bend radius and considerations for bundled installations.
Guides on preventing connector contamination from environment or surface issues, and avoiding water pooling.
Advises checking for and preventing permanent mechanical stress, vibration, or strain on connectors.
