34 | Stavoklima s.r.o. | www.stavoklima.cz | DITRONIC-MANUAL
MODBUS
Conguration and system control permission
from Modbus.
COM
Modbus
READ
DELAYED OUTLET SENSOR
RESPONSE
Setting of time when the heater is o (addi-
tional cooling). 10s increments, range 10-
120s. This function is available for electric air
curtains only. Please proceed carefully when
working with this function.
40 s
OUTLET SENSOR MINIMUM
SWITCHING TEMPERATURE SETTING
This parameter enables to set temperature
f
or short-term turning the electric heater
o, provided that the temperature was
achieved due to overheating of the heater
or as protection or damage to some air curtain components often leading
to re. Temperature is always read from the outlet sensor. Time period the
heater is o is set in outlet sensor response parameter.
This function is available for electric air curtains only.
Please proceed carefully when working with this function. 5°C increments,
range 40-50°C.
45 °C
HEATING / COOLING MODE
The mode interlocks entering of the power
on the display. The current performance in
percentage is expressed in the black eld of
the icon. The red icon indicates active haeting,
the blue one is intended for cooling. Change to
the CHANGE-OVER mode is indicated by the controller by contact making
of terminals 13/14
X
°
Pay attention to selection of the mode.
The following modes may be enabled:
OFF: turning o the outdoor unit
COMBI: the outdoor unit heats up and cools down, and switches
between the modes smoothly
WINTER: the outdoor unit heats up only (default)
SUMMER: the outdoor unit cools down only
DITRONIC-MANUAL
En
To Next Page
Loading...