Stavoklima DITRONIC - Page 6

24 | Stavoklima s.r.o. | www.stavoklima.cz | DITRONIC-MANUAL
0
20.5°C 16.5°C 28.5°C
0
SETTING
You can set other parameters here.
FAN
Fan output is selected with „+“ and „-“
buttons; the output selected is then indicated
with “X” symbol, and the output will be stored
automatically in memory after 1 second.
FAN - EC
Select the fan speed with „+“ or „-“ buttons. Press the button shortly for the
controller to either increase or decrease the fan speed by 10% (quick speed
selection), and press the button longer for the controller to increase or dec-
rease the fan speed continuously depending on whether „+“ or „-“ button is
pressed (slow speed selection). In this menu the instant fan speed is display-
ed graphically and numerically in per cent. After return to main menu the con-
gured fan speed is displayed in 0-100% range by the fan icon. In heat pump
mode, the fan operation depends on the EC01 / EC02 / COMFORT mode.
0
20.5°C 16.5°C 28.5°C
REQUIRED TEMP SETTING
Here, you can set the required temperature
from the selected sensor type
(default)
(room or outlet sensor type). Use „+“ or „-“
buttons to adjust the temperature. Preset
temperature without correction will be loaded
after the controller restart.
20.5°C 16.5°C 28.5°C
DITRONIC-MANUAL
En
HEATING
The power can be selected in three levels via
the buttons +/-. In heat pump mode, the power
is controlled by the temperature dierence.
- E. HESTING *1e.g. 7,5kW) *2e.g. 12,5kW) *3e.g. 20kW)
- WATER HEATING *1100%/ON) *2100%/ON) *3100%/ON)
- HEATING /COOLING *0-100%
Heating or cooling is initiated only if needed based on real temperatures.
20.5°C 16.5°C 28.5°C
COOLING
The power is controlled by the temperature
dierence.
0