Adjust the camera position as needed, and repeat testing until
the desired coverage area is achieved.
When you have completed testing the coverage area, there are
2 methods to exit the test mode:
a. Option 1: Open the front housing, and press the [TEST]
button to exit test mode. The camera will then enter
countdown mode for 1 minute and the front green indicator
will start blinking, giving you 1 minute to leave the coverage
area. The camera will then enter PIR detection mode.
b. Option 2: As a safety precaution, if for any reason you left
the area and forgot to push the test button to exit the test
mode as shown in option 1 above, the camera will
automatically enter the 1 minute countdown mode after it is
left in test mode for 5 minutes. Camera will then enter PIR
detection mode.
Using the camera in PIR detection mode:
Mount the camera to tree or other sturdy object using either a
tree screw (optional accessory) or supplied mounting strap
(You may refer to the mounting suggestions section in this
manual).
To Next Page
Loading...
Need help?
General
