Viewing and deleting the images
The STC-I850 cam offers the user different options for viewing
the images. The external LCD display on the front of the housing
will show the number of images in memory.
To wake the camera from PIR detection mode, press and hold
either the [UP] or [DN] button for about 5 seconds.
The instructions below are based on a camera that is turned off.
Viewing the image on a handheld LCD TV video monitor or your
home TV equipped with an RCA input jack.
For viewing on handheld LCD TV, attach the appropriate cable to the
video out jack on the camera. Insert the other end into the video in
jack on handheld LCD TV monitor.
For viewing on home TV, attach the appropriate cable to the video
out jack on the camera. Insert the other end into the RCA video in
jack on the TV. Make sure to switch to VIDEO IN mode on your
TV. (See your TV owner’s manual for directions)
Turn on both the camera and TV monitor.
Your camera is preset to NTSC TV out system by default. If
To Next Page
Loading...
Need help?
General
