STC-WD1
www.stealthcam.net Toll Free 877-269-8490
15
Programming the Stealth Cam STC-WD1
Switch the camera to the ON position. LCD screen will show “ON” for
few seconds and then display the camera status screen. Press the
MENU button within 30 seconds to enter programming mode. This will
bring up the SETTING screen.
If MENU button is not pressed within 30 seconds, camera will
automatically enter PIR detection mode.
Set the Resolution: The first program setting is resolution. To the right
of Resolution, the word HIGH will be blinking
• Press [OK] button to choose the selection
• Press the [UP] or [DN] button to select the desired resolution
(HIGH/MED/BASE) and press [OK] to save and exit to
CAPTURING setting
To Next Page
Loading...
Need help?
General
