us I n g t h e
S
t e a m mo p
Top Innovations 9
FILLING WITH WATER
1. Make sure Foot-Controlled On/Off Switch is set to
“Off” position (red Power Indicator Light will not be
illuminated) and power cord is unplugged. If unit
has been in use, allow a minimum of 5 minutes
cooling time.
2. Carefully remove Boiler Cap by unscrewing it in a
counter-clockwise direction (FIGURE 3-A).
3. Fill included Measuring Cup with 8.5 oz. (250 ml.)
water, and pour into Boiler through Boiler Fill Hole
(FIGURE 3-B).
NOTE: In order to minimize potential mineral
build-up and prolong the life of your Steam Mop,
it is recommended that distilled or de-mineralized
water be used in the Boiler.
If distilled water is not available, then Boiler
should be cleaned frequently in order to remove
mineral build-up. Refer to Page 12 for details.
4. For maximum usable water (10 oz. / 300 ml.), ll
Measuring Cup with another 1.5 oz. (50 ml.) of
water, and add into Boiler.
5. Replace Boiler Cap by screwing it into Boiler Fill
Hole in a clockwise direction until tight (FIGURE
3-C). Unit is now ready to begin steaming – refer to
Page 10 for operating instructions.
FIGURE 3
A
B
C
To Next Page
Loading...
