MICROFIBER PADS
1. Lay one Microber Pad on a at surface, with white fastener
strips facing upward.
2. Align Mop Head above Microber Pad. Make sure Mop is
oriented with Pad as shown (Figure 1).
3. Press Mop Head rmly down onto Microber Pad. Fastener
strips will adhere to Pad Grips on underside of Mop Head.
The Microber Pad is now attached and ready for use.
4. To remove, use your foot to press down on Microber Pad
Release Tab (Figure 2) while simultaneously pulling the unit
up and away from Microber Pad (Figure 3).
WARNING: Use care when handling a recently used Microber
Pad, as it may still be hot.
Initial Setup
Figure 1
Figure 2
Figure 3
White
Fastener
Strips
Release
Tab
To Next Page
Loading...
