Steamfast SF-710 - Storage & Care; Cleaning and Storage; Mineral Build-Up Removal

ENGLISH
|
11
CLEANING & STORAGE
1. Turn Temperature Control Dial to OFF position. Unplug power cord.
2. Place unit upright to allow Ironing Plate to cool for at least 30
minutes.
3. Open Water Tank Cap and drain any remaining water into a sink or
tub. Close Cap whennished.
4. Wipe Main Body and Ironing Plate with a soft cloth lightly moistened
with water.
• DO NOT clean Ironing Plate with detergents or descalers.
• DO NOT clean Ironing Plate with abrasive or corrosiveproducts.
• DO NOT submerge unit or hold unit under running water.
5. (Optional) For space-saving option, pull and release Handle Collapse
Lever while pressing Handle down.
6. Wrap cord with supplied "hook and loop" fastener when storing.
7. Place unit and Fill Cup in cool, dry location.
MINERAL BUILD-UP
1. Follow STEPS 1-3 under CLEANING & STORAGE section above;
however, leave Water Tank Cap open.
2. Make a mixture of 0.5 oz. distilled water and 0.5 oz. vinegar.
3. Using included Measuring Cup, pour water-vinegar solution into
Water Tank. Close Water Tank Cap.
4. Follow normal steam ironing procedure, as outlined on Page 9. Allow
unit to steam out full contents of Water Tank. When nished, lock
Steam Button in lowered position and unplug unit.
5. Allow to cool for 5 minutes, then rell Water Tank with fresh distilled
water. Repeat STEP 4 until vinegar odor dissipates.
6. Store unit as normal.
Storage & Care