ENGLISH
|
9
OPERATING UNIT
CAUTION: Do not operate when handle is in collapsed position.
STEAM IRONING
1. Follow Filling Water Tank procedure on pg 6.
2. Plug power cord into a convenient electrical outlet.
3. Turn Temperature Control Dial to your desired ironing plate heat
setting. The desired setting should align with the Heating Indicator
Light.
4. When Heating Indicator Light turns off, the sole plate has reached it’s
set temperature.
5. To produce Continuous Steam, set the Temperature Control Dial
between Cotton and MAX. Once set temperature is reached, move
the Continuous Steam Switch to position. Continuous steam will
begin to emit from ironing plate. To stop continuous steam, move
Continuous Steam Switch to position.
NOTE: Water may leak from ironing plate if too low a setting
has been selected. Continuous Steam is only available when the
Temperature Control Dial is set to the heat settings between
Cotton and MAX.
To produce a quick, powerful burst of steam, set the Temperature
Control Dial to your desired setting. Once the Heating Indicator Light
has turned off, direct the ironing plate at your fabric and press the
Steam Burst button. Steam Burst is available on all ironing plate heat
settings.
To Next Page
Loading...
