Steca TR A502 TT - Calling Up the Settings Menu and Selecting a Menu Entry; Setting the Time; Setting the System; Setting the Parameters

26
742.114 | 14.50
EN
9.2 Calling up the settings menu and selecting a menu entry
√ Automatic or Off mode is selected.
1. Press and hold SET for two seconds. The settings menu is displayed, menu entry
flashes.
2. Press  to select a different menu entry.
3. Change the settings as described in the following sections.
9.3 Setting the time
Note
The time must be once more set to the correct values if power is removed for a longer
period of time. After this, the same operating mode is displayed as was active previous
to the removal of power.
√ flashes.
1. Press SET. The hours display flashes.
2. Press  to change the hour.
3. Press SET. The minutes flash.
4. Press  to change the minute.
5. Press SET. The change is adopted.
9.4 Setting the system
Note
A system overview is provided in Section 4.4, p. 10.
√
S yst
flashes.
1. Press SET. The number of the current system flashes.
2. Press  to select another system.
3. Press SET. The change is adopted.
9.5 Setting the functions
√
F
unc
flashes.
X Continue as described in Section 10, p. 28.
9.6 Setting the parameters
Note
Details on the parameters are provided in Section 11, p. 45.
√
P
ara
flashes.
1. Press SET. P:01 (parameter number) flashes.
2. Press  to display a different parameter.
3. Press SET. The value of the parameter is displayed, associated components flash in
the system graphics.
4. Press SET. The parameter value flashes.
5. Press  to change the value.
6. Press SET to adopt the change.
7. Press ESC. The parameter number is displayed (flashing).
8. If necessary, repeat steps 2 – 7.