Steinbach Poolrunner HJ1009 - Operation; Do not operate while swimming!; Risk of electric shock!

1. Press the brush strip
6
into the indentation on
the bottom of the filter unit
3
.
2. Make sure that the brush strip
6
has
completely engaged and fits tightly.
The brush is installed.
Removing the brush
1. Remove the filter unit (see section "Cleaning").
4
5
6
3
2. Open all latches on the top part of the filter unit.
3. Separate the top and the bottom part of the filter unit.
4. Unlatch the hook of the brush strip
6
from the inside and press the brush strip
6
out of the
bottom part of the filter unit
3
at the same time.
5. Take out the brush strip
6
.
The brush is removed.
Operation
WARNING!
Do not operate while swimming! Mortal danger!
Hair or clothing can be sucked in or trapped by the cleaning element, hold persons under
water and, in extreme cases, prevent them from resurfacing.
-
Never operate the device while there are persons in the pool.
-
Prevent any access to the pool as long as the device is in operation.
WARNING!
Risk of electric shock!
Risk of electric shock if the control unit drops into the filled pool while it is connected to the
power supply.
-
Pull the power plug out of the socket before lifting the device out of the pool.
3
6
3
27
en