Steinbach Poolrunner HJ1009 - Starting cleaning; Switching off the device

2. Connect the plug of the floating cable
1
in
the right position to the control unit
5
and
screw the connection together.
3. Attach the control unit
5
at a distance of at
least A=3.5 m to the pool with the safety rope
7
so that it cannot be pulled into the water.
4. Connect the power plug to a grounded socket.
The control unit is connected.
Starting cleaning
1. Press the ON/OFF button
12
.
The device starts moving.
2. Press the CYCLE button
11
to switch to a
different cleaning cycle.
The indicator
10
of the last selected cleaning
cycle starts to blink.
The device starts cleaning
It is normal that the device knocks against the pool wall. You can adjust the speed of the
device with the two nozzles; see section "Basic settings". Cleaning stops automatically at
the end of the set cleaning cycle. All indicators
10
blink.
Switching off the device
Proceed as follows to switch off the device:
1. Switch off the device after the end of the cleaning program.
2. Disconnect the control unit from the power supply and the device.
3. Lift the device out of the pool.
4. Clean the filter unit and the device.
Switching off the device
1. Press the ON/OFF button
12
.
The device is switched off and all indicators
10
are off.
10
1
5
11
A
5
7
12
5
10
12
11
30