3. Press and hold the latch on the bottom part
on one side to open it.
4. Slightly lift the filter unit
and let go of the
latch.
5. Repeat the last two steps on the opposite side.
6. Take the filter unit
out of the bottom part
.
7. Open all latches on the top part of the filter
unit.
8. Separate the top and the bottom part of the
filter unit.
9. Thoroughly rinse the bottom part and the top
part with the filter bag with plain tap water.
10. Connect the top and the bottom part of the
filter unit and close all latches.
11. Rinse the device and the floating cable after
each use with plain tap water inside and out.
The device is clean.
Storage
1. Thoroughly clean the device (see section "Cleaning").
2. Let all parts dry completely.
3. Then store the device and its accessories in a dry and frost-free place (≥ +5 °C) without direct
sunlight.
32
To Next Page
Loading...
