MIDEX-8
English – 17
ENGLISH
Installing or Updating OMS
1. Open the folder “OMS 2.3.8” on the MIDEX-8 CD-ROM and start the pro-
gram “Install OMS 2.3.8”.
This loads the OMS Installer program. In the first dialog that appears, click “Con-
tinue”. This will open the Installer dialog.
2. Use the “Install Location” pop-up menu to define where on your hard disk
the Installer should install the “Opcode” folder.
Among other things, this will later contain the OMS Setup program.
3. Click on the “Install” switch.
OMS 2.3.8 will now be installed on your computer.
❐
If an older OMS version was installed on your computer, it will automati-
cally be updated.
4. Please do now restart your computer!
Same as all other system extensions, OMS will only be launched at system
startup, i.e. when you restart your computer. If you do not restart, OMS will not
be available and therefore errors might occur during driver installation.
• The OMS Installer program has created an “Opcode” folder on your hard disk.
This contains the “OMS Setup” program which you can later use to make the
necessary settings.
• The OMS Installer program has also created an “OMS Folder” folder in your Sys-
tem folder. Please do not move or delete this folder.
To Next Page
Loading...
