STEINEL Spot ONE - About this Document; General Safety Precautions

18
GB
1. About this document
– Please read carefully and keep in a safe place.
– Under copyright.
Reproduction either in whole or in part only with our consent.
– Subject to change in the interest of technical progress.
Symbols
...
!
Hazard warning!
Reference to other information in the document.
2. General safety precautions
!
Disconnect the power supply before attempting any work on the unit.
• During installation, the electric power cable to be connected must not be live.
Therefore, switch o the power first and use a voltage tester to make sure the
wiring is o-circuit.
• Installing the light involves work on the mains voltage supply. This work must there-
fore be carried out professionally in accordance with national wiring regulations and
electrical operating conditions.
• Only use genuine replacement parts.
• Repairs may only be made by specialist workshops.
• Not suitable for use with halogen lamps.
3. Spot ONE / Spot ONES / Spot DUOS
Spot ONESC / Spot DUO SC
Proper use
– LED light for outdoor wall mounting
Spot ONES / Spot DUOS
– The sensor-switched LED light contains an infrared motion detector.
Spot ONESC /Spot DUOSC
– The sensor-switched LED light contains an infrared motion detector and can only
be adjusted via Bluetooth.