Steiner MD448 User Manual

11
ROTARY
MOWER
ATTACHING MOWER TO TRACTOR:
- Operate latch control to open hitch latches.
- Drive tractor into position aligning the quick hitch.
- Be sure both latches engage fully and and are placed in the locked position.
- Stop engine! Do not attempt to install drive belt with engine running.
- Release idler assembly to facilitate easy installation of the drive belt.
- Put belt over drive pulleys and engage or adjust idler assembly.
(See Power Unit Operator’s Manual for PTO belt tension adjustments.)
- Set mower to desired cutting height.
- Start engine and engage PTO slowly to prevent shock load on mower components.
- Mow with front lift lever in “FLOAT” position only.
REAR WEIGHT REQUIREMENTS
The table of requirements for rear weights is based upon average mowing conditions and operator’s weight
of 150 lbs. The recommendations may vary with the weight of the operator, other accessories, and the
mowing conditions. It is the operator’s responsibility to determine the correct amount of weight needed to
improve stability. All weights must be removed when the mower is removed. (See Caution in Power Unit
Operator’s manual.)
INSTALLATION
ledoMtinUrewoPkceD"84kceD"06kceD"27
032/022sthgiew0sthgiew0sthgiew2
014sthgiew2sthgiew4
tonsikcedsihT
dednemmocer
034/024sthgiew2sthgiew4sthgiew5
524sthgiew2sthgiew2sthgiew4
525sthgiew0sthgiew0sthgiew0

Steiner MD448 Specifications

General

Brand	Steiner
Model	MD448
Category	Lawn Mower
Language	English