2
•
•
•
PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS ELECTRICAL APPLIANCE
Warning & Cautions
Only
connect
the Steiss 5
pump
to a Steiss M 5 0 mattress.
Only connect the master control unit of the DX550 mattress to a 220-240V power source
Place
power
cable and
pump
away
from
head end to
reduce risk
of
strangulation
or
entanglement with
any
cord,
cable or pipe.
Keep the
tubes
free of kinks.
Disconnect
the
control unit power plug
before
moving
the bed.
Do
not unplug
the
control unit
by
pulling
the cord.
Only use the DX550
products
indoors.
Only use
this product
if it has an
un-damaged cord
or plug.
Keep the
cord
away
from
heated surfaces.
Do
not
use
this product,
if it has been
dropped
or damaged, or it has been
submerged into
water.
(Do
return
the
product
to a
service
centre to be
examined
and/or repaired).
Do
not
expose the
control unit
to
humidity
or
direct
moisture.
Operation Temp: 15 to 35 degree, 30% to 75% non-condensing
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Never
block
the air
openings
or
insert
any
object into
them.
Never place
mattress
on a
couch
or sofa where the air
openings could
be blocked. Do
not spray
any
aerosols onto
the mattress.
Note
cleaning/washing instructions
later in manual. This
device
is
not
registered
as AP/APG protected.
Do
contact your service
centre if
this product
is
not working
properly.
Use
only manufacturer-approved parts
when
maintaining
or
repairing
the Steiss DX550
Use
only manufacturer-approved accessories with this
device.
All parts and accessories supplied are specifically designed for use with the Steiss DX550
control
unit.
Use of
other parts
and
accessories
in
conjunction with this device
is
not
recommended.
The
control unit
can
only
be
repaired
by an
authorized
technician.
Re-positioning
of the
patient
is
always recommended
when
using
an
alternating pressure
air mattress.
It is
advisable
to
monitor product
when used by, on or near
children
and
physically/mentally
challenged
individuals
If any pain,
redness, irritation, numbness
or
swelling occurs while using cushion,
please
inform
healthcare
professional for
them to
assess
and evaluate the situation.
Should
the carer
decide
to
insert
extra foam or place
this mattress
on
top
of
another mattress,
it is at all
times
the
carer’s responsibility
to
ensure
that there is
adequate/legal clearance from top
of
this mattress
to
the
top
of the siderails.
•
•
•
•
•
•
•
To Next Page
Loading...
