Steiss 5 Series - Quick Start-up Guide; Arrival of Product; Preparation of Area

3. Quick Start-up guide of Steiss DX550
3
ARRIVAL OF PRODUCT
BOX 1: Air-Alternating mattress, pump, carry bag, manual
PREPARATION OF AREA
1. Unpack products
2. Place the Steiss DX550 Alternating Pressure Mattress directly on top of the bed frame and ensure
that the air hose is at the foot of the bed.
CAUTION: When securing the mattress to the bed, please ensure that you are securing onto
the
movable parts of the bed and NOT the actual bed frame, as this will obstruct the mechanical
movement and could cause damage to both mattress and bed. The warranty for both the
mattress and the bed may well be invalidated if damage is caused by this means.
NOTE: When the mattress is opened for the first time, please write today’s date (with a non-
Phenol based pen) in the top white box on the PU cover and add in the ‘same date’ for the
following three years in the bottom white box. This will remind the care team when the annual
service is due.
3. Hang the Steiss DX550 pump at the foot of the bed. Connect the push-fit hose connector from the
foot of the mattress to the air outlet of the pump.
4. Plug the pump power cable into the mains outlet. Ensure that electrical cables are safe and tidy, are not
caught in the bed frame and are free from obstruction. Turn the power on at the mains outlet and turn the
power switch on the pump to the ‘ON’ position.
CAUTION: It is important to routinely inspect power cables to ensure they are not obstructed or
causing a tripping hazard. Check the power cable is not under strain or is damaged.
3. Quick Start-up guide of DX550