Steiss UTS - Installation Guide; Initial System Setup and Modes

5. Installation Guide
66
Initial Set Up
The UTS mattress denes a new product category within the pressure care mattress range spectrum. A step up
from traditional hybrid system. Allows the user to adopt and customize the system to suit a wider range of care
requirements.
1. STATIC COMFORT MODE
Mattress is fully inated and held in static mode with top surface foam in position underneath top PU outer
cover (mattress is plugged in and switched on in standby mode)
2. DYNAMIC COMFORT MODE
Mattress is fully inated and operated in auto dynamic mode with top surface foam in position underneath.
Top PU outer cover.
3. DYNAMIC MODE (AUTO)
Mattress is fully inated and operated in auto mode with patient in direct contact with alternating cell surface for
maximum reactive therapy. Foam top surface is stored inside the pocket beneath the dynamic cells.
4. DYNAMIC MODE (MANUAL)
Mattress is fully inated and operated in manual dynamic mode with patient in direct contact with Alternating
cell surface (underneath top PU outer cover). Surface pressure is adjusted manually via handset to maximize
patient comfort (constant low-pressure therapy – CLP). This is particularly benecial to hyper sensitive patients
where the benets of the reactive therapy are matched to comfort.