6947400000
23
POST GAS ( Post-gas time ) Adjustable from 0,1
to 25 sec.
INDUCTANCE ( XL ). Adjustable from -50 to + 50
in synergic mode and adjustable from 25 to 200%
in Manual Mode.
TIME ON ( Arc ON Time ) Adjustable from 0,1 to 10
sec. ONLY IN SPOT MODE .
TIME OFF ( Arc OFF time ) Regolabile from 0,1 to
10 sec . ONLY IN SPOT MODE .
If the welding current exceeds the nominal value
accepted by the machine, a protection intervenes
which automatically lowers the welding voltage.
.
The operator must reset the parameters with lower
values than those which brought the machine into
protection mode
PROTECTION FOR
OVERCURRENT
If the welding current is more than the nominal
value accepted by the machine there is a
protection that automatically reduces the welding
voltage.
If this happens, the parameters on the display will
also flash when welding is finished.
The operator must set again the machine with a
lower parameter compare to the original parameter
that sent in protection the machine.
FUNCTION OF STORING AND
LOADING WELDING
PARAMETERS (JOB MODE)
Function active for all welding modes
This function allows you to store and load at any
time all the settings made on the power source. It
is possible to save 30 welding parameters
( settings)
STORAGE OF WELDING PROGRAMS
1) Press the button JOBS to enter in the JOB List
2) Turning the encoder V/ (Fig.2, ref.7) choose the
position where to save the welding parameter.
3) Press the button SAVE (ref.8) to save the
parameter.
4) After saving, the saved parameter will be
partially displayed in the box selected for saving.
4) After saving, press the button HOME to return to
the main screen.
RECALL STORED WELDING PROGRAMS
1) Press the JOBS button to enter the JOBS LIST
screen.
2) Turn the encoder V/ (Fig.1, ref.7) and choose
the number of the program to recall.
3) Press the button RECALL to recall the saved
parameter.
4) Once the recall has taken place, you will
automatically return to the main screen and you
will be able to see the JOB number on which you
are working in the JOB box.
If a recalled program is modified (wire speed,
To Next Page
Loading...