EasyManua.ls Logo

stellar labs 7621 - User Manual

Default Icon
56 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Heavy-Duty
Telescopic Cranes
Owner’s Manual
Stellar Industries, Inc.
190 State Street
PO Box 169
Garner, IA 50438
800-321-3741
Fax: 641-923-2811
www.stellarindustries.com
Subject to Change without Notication.
© 2022 Stellar Industries, Inc.
Rev 1
PN 115278
Safety • Operation • Maintenance • Troubleshooting
Models:
7621 7630
8621 8630
9621 9630
10621 10630
12621 12630
Notice: A copy of this manual must remain with the equipment at all times.
For a printable download copy, please visit: www.stellarindustries.com
Courtesy of CraneMarket.com

Questions and Answers

  • J
    Jennifer LopezSep 13, 2025
    Why don't Winch up and Extension out work when the crane is stowed on my stellar labs 7621?
    • C
      Carl LeeSep 13, 2025
      If the Winch up and Extension out functions do not operate while the main boom cylinder is fully retracted or the crane is stowed in the boom rest, raise main lift cylinder slightly, this condition is due to the safety systems of the crane.
  • T
    Tyler RodriguezSep 15, 2025
    Why aren't Winch 'Up', Main Cylinder 'Down', and Extension Cylinder 'Out' working on my stellar labs 7621?
    • J
      Johnathan MorenoSep 15, 2025
      If Winch “Up”, Main Cylinder “Down”, and Extension Cylinder “Out” are the only functions that don’t operate on your Stellar Labs Construction Equipment, consider the following: * Make sure that the anti-two block weight and chain on the end of the boom are straight so they slide easily along the wire rope cable. * Make sure that the limit switch is working properly. Disconnect the two wires connected to the limit switch and tie them together. If all functions operate, replace the limit switch. * Make sure that the cord for the cord reel is undamaged. Check the continuity of the cord. Disconnect the cord reel from the crane harness and bypass the harness connection. If the crane operates properly, replace cord reel.
  • M
    Michael BookerNov 20, 2025
    Why is my Stellar Labs Construction Equipment crane operating slowly?
    • S
      Sara MasonNov 20, 2025
      If your Stellar Labs Construction Equipment crane is operating slowly, consider the following: * Ensure the crane is receiving the recommended hydraulic flow. * Check the hydraulic fluid level in the reservoir and add fluid if needed. * Check the hydraulic fluid temperature. * Inspect the valve bank orifice for any blockages; replace the orifice if it's plugged (contact Stellar Customer Service for instructions). * Make sure the proportional valve is receiving 12V power when fully engaging the transmitter trigger. If there is no 12V power while pulling the trigger, check for loose connections inside the transmitter or replace the handle trigger assembly. If the proportional valve is receiving 12 volts, loosen the solenoid holding nut and check to see if the solenoid coil is magn...

stellar labs 7621 Specifications

General IconGeneral
Brandstellar labs
Model7621
CategoryConstruction Equipment
LanguageEnglish

Related product manuals