Stelpro B1T1ER - Installation Steps; Step 1: Remove Front Panel; Step 2: Remove Wiring Coverplate; Step 3: Perform Electrical Connections

INS-B1T1ER 1112
STEPS
1
2
Remove the front panel by tilting its
bottom part upward.
Remove the coverplate of the wiring
compartment by loosening the screw
(note that this coverplate will no
longer be required as the thermostat
is equipped with its own coverplate).
3
Perform the electrical connexions as
indicated on the following diagram.
Right junction box
Boîte de jonction droite