Stelpro B1T1ER - User Manual

To Next Page

INS-B1T1ER 1112

www.stelpro.com

WARNING

Stelpro Design recommends that the installation of this product be

performed by a certified electrician. Before installing this product,

ensure that the breaker at the electrical panel is switched to the

OFF position.

Make sure that all the electrical connections are secure and have

been made properly. Pull each wire to ensure it is not loose in the

connector or the terminal board as this may cause a fire.

Right installation only.

Note that the power supply must come from the right side.

For a video of the installation

process, visit our Web site at

www.stelpro.com/en/B1T1ER.php

DETAILED INSTALLATION

INSTRUCTIONS FOR B BASEBOARD

HEATER THERMOSTAT (B1T1ER)

Need help?

Do you have a question about the Stelpro B1T1ER and is the answer not in the manual?

Summary

Note that the power supply must come from the right side.

Installation by a certified electrician; ensure breaker is OFF. Secure all connections.

Tilt the bottom part of the front panel upward to remove it.

Loosen the screw to remove the wiring compartment coverplate.

Make electrical connections as indicated on the diagram.

Properly secure the sensor into the slot, directed downward.

Position wire connectors on the left side and secure them.

Follow steps A-D to affix and secure the thermostat correctly.

Insert the upper part of the front panel, then gently press its downward half into place.

General