The measuring process starts automatically at the
next measuring time and the unit displays the
measured value briefly in the display before
returning to the status screen. After 30s, the
instrument switches off automatically.
In the automatic measuring mode, an additional
measuring procedure can be initiated manually
outside of the set measuring cycle: press OK to start
a measuring procedure outside of the measuring
cycle. After approx. 2s the measurement result will
be displayed and saved in the data logger, after 30s
the instrument switches off automatically.
For measurements without a probe or with a defect
one, the two result lines show ----% and ---- ° C.
Clean and dry the probe with a piece of cloth before
setting the zero point or before re-calibrating. Further
measurements can then be carried out immediately.
6. Video HOW-TO-USE
tablet.
To Previous Page
Loading...