STERWINS EGT2-30.4 - End of Life

174
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
Problems Probable causes Solutions Qualification
Poor trimming
quality
There is no more line on
the spool
Change the line CUSTOMER
The automatic system of
the spool is defective
Change it by a new one CUSTOMER
The engine lacks
of power
The carbon brushes are
about to be consume
Change carbon
brushes/spring/
support
AFTER SALES
SERVICE
The carbon brushes
spring is not enough
strong
Change carbon
brushes/spring/
support
AFTER SALES
SERVICE
The product
suddenly stops
Electrical cable is out of
service
Visual check of the
cable and change it
CUSTOMER
The motor protection
has blocked the machine
because of overload
Wait a few minutes
for the engine to cool
down
CUSTOMER
Vibration
Nuts / screws are not
well tight
Screw the nut(s) /
screw(s)
CUSTOMER
The line is not cut
properly
The line cutter on the
guard is out of service
Change the line cutter CUSTOMER
The guard is broken Change the guard CUSTOMER
6.6 FATAL CIRCUMSTANCES : CRITICAL ISSUES
Problems Solutions
The machine smokes during operation
Immediately stop the machine, Disconnect
the power plug then speak to service
center
7. END OF LIFE
Electrical products should not be discarded with household products. Used electrical
products must be collected separately and disposed of at collection points provided for
this purpose. Talk with your local authorities or dealer for advice on recycling.