STERWINS EGT2-30.4 - Residual Risks; Technical Data

166
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
2.10 SERVICE
A) Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
B) Have the product checked by a qualified professional and repaired, if
necessary, before you operate it again.
C) Never replace the non-metallic cutting means with metallic cutting
means.
2.11 RESIDUAL RISKS
• Familiarise yourself with the use of this product by means of this
instruction manual. Memorise the safety directions and follow them to the
letter. This will help to prevent risks and hazards. Always be alert when
using this product, so that you can recognise and handle risks early. Fast
intervention can prevent serious injury and damage to property. Switch o
and disconnect from the Power source if there are malfunctions.
• Even if all instructions are strictly followed, there are still some factors
that could lead to hazards, such as :
- Thrown out pieces of the work piece.
- Vibration injuries : use designated handles and try to reduce working
time and exposure.
- Injuries caused by noise : wear ear protection and reduce working time
and exposure.
- Inhalation of dust and particles.
- Wear eye protection at all times.
If you experience any of these factors while using the machine, stop the
machine consult your doctor immediately
• Injuries may be caused or aggravated by prolonged use of a tool. When
using any tool for prolonged periods, ensure you take regular breaks.
• Prolonged use of the product exposes the user to vibrations that can cause
a range of conditions collectively known as hand-arm vibration syndrome
(HAVS) e.g. fingers going white; as well as specific diseases such as carpal
tunnel syndrome.
• To reduce this risk when using the product, always wear protective gloves
and keep your hands warm.
2.12 TECHNICAL DATA
Model EGT2-30.4
Rated voltage (V) 220 - 230
Rated power (w) 600W
Frequency (Hz) 50
Cutting width (cm) 30
Cutting system Line
Line size diameter (mm) 2,0
Net weight (without packaging)(Kg) 2,65
Guaranteed sound power level (dB(A)) 96
measured sound presure level at operator
position (dB(A))
L
PA=76.2, KPA=2.5
Measured sound power level (dB(A)) L
WA=93.5 dB(A), KWA=2.12 dB(A)
Working current (A) 2,4-3,4
Maximum current (A) 3,4
Vibration level (K=1.5m/s
2
) 5 m/s
2
No-load speed (min
-1
) 8000±10%
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another. The declared vibration total