STERWINS EGT2-30.4 - Preparation for First Use

168
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
locks in place.
NOTE: Ensure the connection is properly secured. Tighten the knob so far until there is not gap
between the handle and handle support.
Attaching the spool guard: illustration
2.3
and
2.4
Align and attach the spool guard to the power head. Secure the guard by four screws. Remove
the protective tap of line cutter.
Attaching the flower guard: illustration
2.5
Clamp the flower guard into holes on the power head. Lead it to working position when trimming
near flowers. After use, turn it upwards.
3.3 PREPARATION
Safety equipment and protective clothing : illustration
3.1
Make absolutely sure to wear the appropriate close-fitting protective clothing such as protective
pants, gloves and safety shoes. Wear a safety helmet with integrated hearing protection and a
face guard. Do secure long hair so that it is above shoulder level.
Use the following safety clothing and protective equipment when operating the product:
- Hearing protectors
- Gloves with approved saw protection
- Protective overall
- Safety glasses
- First aid kit in case of injury.
Connecting to the mains: illustration
3.2
Fix the power line to the handle hook and connect plug to the mains.
3.4 FIRST USE
WARNING ! READ THE « SAFETY INSTRUCTION » SECTION AT THE
BEGINNING OF THIS MANUAL INCLUDING ALL TEXT UNDER
SUBHEADING THEREIN BEFORE USING THIS PRODUCT.
Pay particular attention using the machine for the first time: focus and dedicate all your
attention to this first use. Make the first trial on a free space with no obstacle and no surrounding
element.
Before use, check that the trimmer in good working order,as follows:
1. Ensure the trigger is free from pressure and the plug is disconnected from the mains supply.
2. Examine the general condition of the tool. Inspect the guard and switch trigger. Check for
loose screws, misalignment, and binding of moving parts, improper mounting, broken parts and
any other condition that may aect its safe operation. If abnormal noise or vibration occurs
during operation, turn machine o immediately and have the problem corrected. Do not use a
damaged tool and attach a label “DO NOT USE” to the tool.
3. Ensure that you are on a flat surface and have secure footing.