169
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN
3.5 OPERATION & CUTTING TIPS
WARNING : DO NOT INSERT OR DISCONNECT THE POWER PLUG
WHILE THE TRIGGER IS PRESSED OR WHILE THE POWER TOOL IS
IN MOTION.
CAUTION ! ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER
MASK IF THE OPERATION IS DUSTY. USE OF PROPER GLOVES AND
SUBSTANTIAL FOOTWEAR IS ALSO RECOMMENDED.
Switching on/o : illustration
4.1
to
4.2
Connect the plug to the power. Press the switch trigger to start the tool. To switch o, release
the switch trigger. WARNING! The tool runs for approximately 5 seconds after it has been
switched o. Let the motor came to a complete standstill before setting the tool down.
NOTE: This appliance has a cutting line automatic feed head. Do not strike the cutter head on
the ground as this will damage the product.
Note: The cutting line will stretch approximately 8 mm at each stop and start until the line has
reached the line cutter. The overfed line will be cut by the line cutter.
Cutting with the spool : illustration
4.3
Make sure that the work area is free of rock, debris, cables and other foreign objects. Start
the tool before approaching the grass to be cut. Cut the grass by swinging the tool from right
to left and the tool inclined forwards at an angle of about 30. Light cuts are better than heavy
cuts as they allow the cut grass to fall away from the spool preventing the grass from clogging
the spool. Start cutting nearest the mains power source and work away from it to make it
easier to avoid the cable. High grass should be cut in layers always beginning from the top. Do
not cut damp or wet grass. Do not overload your tool. Avoid wearing the line out quickly by
knocking against hard objects(stones, walls, fences etc). Watch out for kickbacks in the events
of impact with hard objects. After finishing the cutting operation, keep the head close to ground
level,release the switch trigger and aollow the motor to come to a complete standstill. Place
the tool on the ground, switch o and remove the cable plug from the main supply.
NOTE: TRIM LONGER GRASS IN STAGES; DO NOT CUT LONG GRASS
IN ONE CUT. FOR THE BEST RESULTS, CUT LONGER GRASS IN
STEPS.
Adjusting the trimmer head: illustration
4.4
Keep the rotation knob depressed and move the power head to one of optional positions.
Release the knob when you feel the engagement.
Adjusting tube length: illustration
4.5
Unlock the adjusting connector at first. Move the upper tube until the desired length is reached.
Relock the connector for securely holding the upper tube.
Changing working mode: illustration
4.6
Grip on lower tube firmly by one hand while pulling the adjusting connector towards handle
with another. Have the lower tube relatively rotated to the upper tube until you feel the
engagement.
Extending the line for spool set
1. Automatic line feed: The cutting line is fed at every stop and start controller by switch trigger.
To Next Page
Loading...
