266
2. SAFETY INSTRUCTIONS
EN
no retpahc eeS .gnisu era uoy tnemhcatta gnittuc eht rof draug dednemmocer
Technical data. Never use a cutting attachment without an approved guard. If
you to free yourself from the machine.
er is designed to keep noise levels to a minimum and to direct
exhaust fumes away from the user. Never use a machine that has a faulty
er is securely attached to the machine.
eruces ot desu si tun gnikcol A –
in the opposite direction to the direction of rotation of the cutting attachment.
To remove it, undo the nut in the same direction as the cutting attachment
rotates. (CAUTION! The nut has a left-hand thread.) Tighten the nut using the
spark plug wrench with a suitable torque (25 - 30 Nm).
rehto ro gnippord retfa dna esu hcae erofeb enihcam eht tcepsni syawlA •
parts. Never operate a machine that is damaged, improperly adjusted, or is not
completely and securely assembled.
incorrectly it can result in serious and/or fatal personal injury.
when using the trimmer. The guard extension shall always be removed from
the cutting attachment guard when using the metal blade.
,.g.e ,strap elbisiv eht yllaicepse ,gnitrats erofeb skael rof metsys leuf kcehC •
degamad esiwrehto ro dekcarc rof dna ).cte ,swercs ,stun( strap esool rof tcepsnI •
heads or cracked, bent, warped or otherwise damaged blades before each
staring. Replace damaged heads or blades before using the power tool. Always
keep blades sharp. Keep the handles clean and dry at all times; it is particularly
important to keep them free of moisture, pitch, oil, fuel mix, grease or resin in
To Next Page
Loading...
Need help?
General
