268
2. SAFETY INSTRUCTIONS
EN
.krow gnitrats erofeb ezis ruoy tius ot pirg dnah dna ssenrah gniyrrac tsujdA •
manual for proper control and less fatigue in operation. To be better prepared
in case of an emergency, practice releasing the unit from the harness as quickly
as possible.
and thumbs around the handles. Keep the cutting attachment below waist
cient rest periods and regularly change working positions
during operation.
yna no ro reddal a no krow reven ,lortnoc fo ssol morf yrujni fo ksir eht ecuder oT •
other insecure support. Never hold the cutting attachment above waist height.
cient fuel for a few days work, not to exceed 30days of storage.
Store in approved fuel-containers only. When mixing:
.dexim eb ot lio dna enilosag fo seititnauq eht tuo erusaeM .1
fo lla ruoP .reniatnoc leuf devorppa ,naelc a otni enilosag eht fo emos tuP .2
the oil into the fuel container. Pour the rest of gasoline in the oil container and
agitate well, then pour the mixture into the fuel container.
eht no noitacidni raelc a tuP .etunim eno tsael ta rof reniatnoc leuf eht etatigA .3
outside of the container to avoid confusing it for gasoline or other containers.
Machine use and care
The fuel is highly ammable. Do not smoke or bring any
ame or sparks near fuel. Clean the fuel cap and the area
around it. Check for fuel leakage while refueling and during opera-
tion. If fuel leakage is found, do not start or run the engine until the
leak is xed and any spilled fuel has been wiped away. Take care not
to get fuel on your clothing. If this happens, change your clothing
immediately.
FUEL WITH NO OIL (RAW GASOLINE) – It will cause severe damage to
the engine inner parts very quickly. OIL FOR 4-CYCLE ENGINE USE or
WATER COOLED 2-CYCLE ENGINE USE – It can cause spark plug fouling,
exhaust port blocking, or piston ring sticking.
To Next Page
Loading...
Need help?
General
