Please check special note of the following important points before installation
1. Assembly introduction
Important safety installation of the STEX treadmills.
Please confirm the horizontal floor.
Position the treadmill on a clear, level surface. Otherwise Not only Vibration will be occurred but also User would
be wounded.
We strongly recommended laying a mat under the treadmill to prevent damage against the shock of vibration
DO NOT locate the treadmill in areas with a high humidity and a lot of dust.
DO NOT locate any inflammable liquid of material near the treadmill.
Locate the treadmill with the enough intervals to operate easily and safely.
- Minimum space : Rear 1.2m, Left & Right 0.6m
2. How to carry the STEX Treadmill
To carry the STEX Treadmill
Lift the rear of the treadmill for the easy movement.
3. Parts included
Operation Manual, Warranty Card
10mm T-Wrench / 6mm L-Wrench / Plus driver
Hexagon socket head (M820mm - SEMS) 14ea (Silver)
Hexagon socket head (M820mm - SEMS) 4ea (Black)
Hexagon socket head (M840mm - SEMS) 4ea (Black)
Machine pan head (M512mm - SEMS) 4ea (Black)
Main Frame Assembly / Console Middle Assembly / Console Top Assembly
Display Support 1set
4. If you have any problem
If you have any problem for STEX treadmill S23T series, Please contact our sales dealer or our service center by
phone of E-mail. In order to reply promptly as for your particular issue situation, Please refer to the sample of Claim
Report in the last page. It would be appreciated if you fill out the form like the sample. Then we will proceed your
To Next Page
Loading...
