stex S25T - Pre-operation Check

< 48 >
- Connect the HDMI cable as shown.
5) Earphone cable - S25TX
- Connect the Earphone cable as shown.
6) I POD OUTPUT cable - S25TX
- Connect the I POD OUTPUT cable as shown.
7)
RF cable - S25TX
- Connect the RF cable w i th as shown.
8) USB cable - S25TX
- Connect the USB cable as shown.
② Stand the DISPLAY TOP ASSEMBLY.
Fasten 4 bolts(M8
×
50 mm ) with 6mm L-wrench .(2)
Pre-operation check!
① Ensure that all screws are tight.
② Ensure that the treadmill is properly leveled and stable.
③ Ensure that the leveler nuts are tight.
④ Read the entire operation manual before using the treadmill.