STI S.r.l. – Via Dei Caravaggi 15, 24040 Levate (BG) – ITALY www.imi-critical.com
Manual 5020, rev.03 07/2021 - SC/VHS 2
1.6 Applicable Standards and Directives
- EN ISO 12100: 2010: Safety of machinery - General principles for design. Risk asses and
risk reduction.
- EN ISO 80079-36: 2016: Non-electrical equipment for explosive atmospheres – Basic method
and requirement.
- EN ISO 80079-37: 2016: Non-electrical equipment for explosive atmospheres – Non electrical
type of protection constructional safety “c”, control of ignition source “b”,
liquid immersion “k”.
- 2006/42/EC Machinery Directive.
- 2014/68/EU Pressure Equipments Directive (PED)
- 2014/34/EU Directive concerning equipment for use in potentially explosive
atmospheres (ATEX)
- 2014/35/EU Directive for Low Voltage Equipment (LV)**
- 2014/30/EU Directive relating to the Electromagnetic Compatibility (EMC)**
** Applicable only when electrical control panel is supplied integrate with the actuator.
1.7 Symbology Used
1.7.1 Signs of warning
Be careful where these symbols are shown, they indicate a potentially hazardous situation and they
warn that if the steps are not properly performed, MAY RESULT CAUSING serious injury, death or
long-term risks to the health of exposed persons.
1.7.2 Sings of obbligation