STIEBEL ELTRON Accelera 300 - 10.6 Unpacking the water heater; DANGER Injury from tipping over

ENGLISH
WWW.STIEBEL-ELTRON-USA.COM ACCELERA 300 | 19
INSTALLATION
INSTALLATION
10.6 Unpacking the water heater
Ensure that the casing material in the lower
section will not be damaged.
Advice - The longer you keep the packaging
foil wrapped around the water heater, the
longer it will be protected against damage.
» Remove the packaging straps.
» Push the packaging foil far enough upwards that
the pallet is freely accessible.
» Remove the water heater carefully with the
polystyrene
®
packaging from the pallet.
DANGER Injury from tipping over
The water heater has a high centre of gravity
and a low overturning moment. Ensure that
the water heater does not overturn when you
remove it from its pallet.
» Slide the packaging foil far enough upwards to be
able to remove the first polystyrene
®
profiles from
the sides. These polystyrene
®
profiles on the sides
are used as installation aids in the following steps.
26_03_01_1395
» Separate the lower packaging section at the
dividing line. For this, make an incision of approx.
1.25" (30 mm) into both sides of the dividing line.
26_03_01_1396
» Slightly tilt the water heater.
DANGER Injury from overturning
Secure the water heater against overturning
by getting a second person to support the
water heater.
» Push a wooden support underneath the lower part
of the packaging.
» Break out the free semi-shell of the lower section of
the packaging.