www.stiebel-eltron.com DEL SL electronic LCD | 33
INSTALLATION
Installation
Water installation on finished walls, fitting the appliance cover
D0000061397
4
3
2
1
1 Back panel guides
2 Screw
3 Cover guides
4 Pipe aperture
Cleanly break out the knock-out apertures in the appliance
cover. If necessary, use a file.
Note
If the tap connection pipes are slightly offset, the appli-
ance can be sealed using the tabs on the cover guides.
If the tap connection pipes are offset, do not fit any
back panel guides.
If installing tap connection pipes which are not offset, break
off the tabs on the cover guides.
Click the cover guides into place in the pipe apertures.
Position the back panel guides on the pipes. Push them to-
gether. Then push the guides until they are resting against
the back panel.
Secure the back panel at the bottom with a screw.
Installation of lower back panel with threaded fitting on
finished walls
You can install the lower back panel after fitting the taps.
1
2
26�02�02�1080
1 Connection pieces delivered in the pack
2 Screw
Cut open the lower back panel at the markings.
Fit the lower back panel by bending it out at the sides and
guiding it over the pipes.
Insert the connection pieces into the lower back panel from
behind.
Click the lower back panel into place.
Secure the lower back panel with a screw.
Wall mounting bracket when replacing an appliance
When replacing an appliance, you can use an existing wall mount-
ing bracket of a StiebelEltron appliance (except for a DHF instan-
taneous water heater).
Press the appliance over the threaded stud of the existing
wall mounting bracket. When doing so, push through the soft
seal in the back panel of the appliance. If necessary, use a
screwdriver.
DHF replacement
26�02�02�0815�
Reposition the threaded stud on the wall mounting bracket
(the stud has a self-tapping thread).
Rotate the wall mounting bracket 180° and mount it on the
wall (the DHF logo is then turned towards the reader).
Installation with offset tiles
To Next Page
Loading...
