www.stiebel-eltron.com DHE | 83
INSTALLATION
Commissioning
ENGLISH
D0000073198
Connect the programming unit connecting cable to the PCB.
Note
For undersink installation, the appliance cover should be
turned the other way up for easier operation; see chapter
"Installation alternatives/ Rotated appliance cover".
D0000053280
Hook the appliance cover at the top rear into the back panel.
Pivot the appliance cover downwards. Check that the appli-
ance cover is securely seated both top and bottom.
Tick the selected connected load and rated voltage on the ap-
pliance cover type plate (on both sides). Use a ballpoint pen
to do this.
Secure the appliance cover with the screw.
Fit the fascia to the appliance cover.
Remove the protective film from the user interface.
D0000053281
Switch on the power supply.
11.2.1 Appliance handover
Explain the appliance function to users and familiarise them
with how it works.
Make the user aware of potential dangers, especially the risk
of scalding.
Hand over the instructions.
To Next Page
Loading...
