www.stiebel-eltron.com DHEConnect | DHETouch | 73
OPERATION
Settings
If the battery is empty, follow chapter "Troubleshooting/ Mini
wireless remote control battery replacement".
4.5 New/ Additional programming unit learning
The DHEprogramming unit allows you to operate the device re-
motely (for wireless remote controls, see chapter "Installation/
Accessories"). Encoding prevents the transmitters of third party
appliances changing the settings.
Obstacles can affect the transmission path between device and
programming unit.
You can perform the programming unit learning as follows:
Using the programming unit built into the instantaneous
water heater, open the "Service/ Wireless/ Connect other
wireless subscribers" menu item.
Open the "Service/ Wireless/ Log on programming unit"
menu item on the programming unit to be learned.
Press the "OK" button on the programming unit to be
learned.
4.6 New mini wireless remote control learning
You learn the mini wireless remote control as follows:
Using the programming unit built into the instantaneous
water heater, open the "Service/ Wireless/ Connect other
wireless subscribers" menu item.
Press the mini wireless remote control "+" button for 3sec-
onds (pairing process is acknowledged by the red LED).
4.7 Recommended settings
Saving energy
The following recommended settings will result in the lowest en-
ergy consumption:
- 38°C for hand washbasins, showers, bath
- 55°C for kitchen sinks
Thermostatic valve
If you are operating the appliance with a thermostatic valve, we
recommend setting the temperature on the appliance to above
50°C. The required temperature can then be set at the thermo-
static valve.
To Next Page
Loading...
Need help?
General
