OPERATION
Preparations
22 | DHM www.stiebel-eltron.com
3. Preparations
Flush the water line thoroughly.
Water installation
A safety valve is not required.
Taps
Use suitable taps (see chapter "Appliance description/
Accessories").
Note
Fitting the special aerator supplied provides an optimum
water jet.
4. Installation
4.1 Installation site
Install the appliance in a room free from the risk of frost and near
the draw-off tap.
Ensure that the lateral fixing screws for the cover are always
accessible.
The appliance is only suitable for undersink installation (water
connections at the top).
DANGER Electrocution
Protection rating IP25 is only ensured if the appliance
back panel is fitted.
Always fit the appliance back panel.
4.2 Installation options
Undersink installation, pressure-tested, with pressure-tested
tap
26�02�05�0093
To Next Page
Loading...
