STIEBEL ELTRON DHM 3 - 5 Commissioning; Initial Start-Up; Appliance Handover

26 | DHM www.stiebel-eltron.com
INSTALLATION
Commissioning
!
Material losses
Take note of the type plate. The specified voltage must
match the mains voltage.
 Connect the power cable as shown in the wiring diagram
(see chapter "Specification/ Wiring diagram").
5. Commissioning
5.1 Initial start-up
26�02�05�0087
 Fill the appliance by running the tap several times until the
pipework and appliance are free of air.
 Carry out a tightness check.
 Insert the power cable plug, if present, into the standard
safety socket or set the fuse/MCB.
 Check the function of the appliance.
5.2 Appliance handover
 Explain the appliance function to users and familiarise them
with its operation.
 Make users aware of potential dangers, especially the risk of
scalding.
 Hand over these instructions.