STIEBEL ELTRON DHM 3 - Page 36

36 | DHM www.stiebel-eltron.com
INSTALLATION
Installation
10.2.1 Appliance installation
 Mount the appliance on the wall.
Note
The wall must have a sufficient load-bearing capacity.



26�02�05�0083
 Undo the cover fixing screws by two turns.
 Undo the snap fastener using a screwdriver.
 Remove the appliance cover with the heater towards the
front.


26�02�05�0084
 Using pliers, break out the knock-out for the power cable
in the appliance cover. Correct the contours with a file if
necessary.
 Use the appliance back panel as a drilling template.
 Secure the appliance back panel to the wall with suitable
rawl plugs and screws.