STIEBEL ELTRON LWZ 130 - Page 41

OPERATION
Settings
www.stiebel-eltron.com LWZ 130 | LWZ 130 Enthalpie | 41
ENGLISH
f Set the end time. Press "OK".
The fan program is now set.
f In standard view, select "Time program mode". Press "OK" to
activate the fan program.
Note
If there are fan programs with identical times, the higher
level switching time pairs and individual days of the week
have priority.
Example
Switching time pairs Stage
Monday to Friday
06:00 - 22:00 2
22:00 - 06:00 1
Saturday, Sunday
07:00 - 23:00 2
23:00 - 07:00 1
Fan program Stage Start End
Day of the week or time
block
Monday - Friday 1 22:00 24:00
Monday - Friday 1 00:00 06:00
Saturday - Sunday 1 23:00 24:00
Saturday - Sunday 1 00:00 07:00
For times where there is no fan program defined, the unit operates
at fan stage2.
Deleting switching time pairs
f To delete a switching time pair, select the "Start" or "End" of
a switching time pair.
f Turn the Touch-Wheel to the left beyond 00:00 until dashes
"-- --" are displayed. Press "OK".
Resetting one of the times to "--:--" automatically resets the other
time of the switching time pair.
Deleting day of the week or time block
f Delete all three switching time pairs to delete the fan pro-
gram for the weekday or time block.
4.4.4 "Settings" menu
 Settings
Value
 View Code for qualified contractor
 General
 Time/date Day
Hour:Minute
 Language English
English
Francais
Nederlands
Italiano
Polski
Cesky
Magyar
Slovensko
中文
Slovensky
日本語
 Contrast 1 - 10
 Brightness %
 Touch sensitivity 1 - 10
 Touch boost 1 - 10
 Prog. unit software
 Air flow rate Only for qualified contractors
 Favourites
 F1
F2
F3
Bypass status
Extract air temp.
Extract air hum.
Filter runtime
Device software version
Device software patch
Mobile device serial no.
 Humidity prot. Only for qualified contractors
 Intens. vent.
 Intens. vent. time min
 Heat recovery bypass
 Set room temperature °C
 Operating mode heat recovery bypass Disabled
Bypass/window contact
Outdoor air routing auto-
matic
Extract air routing autom.
 Cooling/heating, heat recovery bypass Cooling/heating
Cooling
Heating
 Frost protection Only for qualified contractors
 Condensate prevention Only for qualified contractors
 Enable fan Off
On
 Ventilation unit
 Device software version
 Device software patch
 Mobile device serial no.
Settings
 View
Only those parameters which are enabled for the appliance user,
and therefore accessible without a code, are shown in the default
settings.
Qualified contracts can use the "View" parameter to enable actual
values and parameters, which are reserved for qualified contrac-
tors.
 General
 Time/date
The "Time/date" parameter enables you to set the day of the week
and the current time.
 Language
The "Language" parameter enables you to select the language of
the display.
 Contrast
The "Contrast" menu item allows you to adjust the contrast of
the display.
 Brightness
The "Brightness" menu item allows you to set the brightness of
the display.