ENGLISH
www.stiebel-eltron.com WWK 220-300 electronic | 23
INSTALLATION
Maintenance and cleaning
14.8 Replacing the power cable
WARNING Electrocution
If the power cable is faulty, replace it with a new one.
The power cable should only be replaced by a qualified
contractor (connection type X).
14.9 Fitting the casing ring
WARNING Electrocution
Reconnect the earth cable to the casing ring.
D0000034814
Fit the upper casing ring. The casing ring overlaps along the
joint. A tab on one end clips into the recess at the other end
of the casing ring.
Secure the casing ring with screws.
Fit the pipe collar of the condensate drain and the conden-
sate drain bend.
14.10 Fitting the appliance cover
WARNING Electrocution
Reconnect the earth cable to the appliance cover.
Place the cover back on the appliance.
Connect the cable linking the control with the appliance PCB
to the back of the fascia.
Insert the control fascia.
Secure the appliance cover and the control fascia using the
screw at the top of the control fascia.
314104-38523-9034_WWK_220-300_electronic_en_pl.indb 23 24.02.2015 10:33:57
To Next Page
Loading...
