STIEBEL ELTRON WWK 220 electronic - Page 3

ENGLISH
www.stiebel-eltron.com WWK 220-300 electronic | 3
SPECIAL INFORMATION
SPECIAL INFORMATION
- The appliance may be used by children aged8
and up and persons with reduced physical, sen-
sory or mental capabilities or a lack of experience
and know-how, provided that they are supervised
or they have been instructed on how to use the
appliance safely and have understood the result-
ing risks. Children must never play with the ap-
pliance. Children must never clean the appliance
or perform user maintenance unless they are
supervised.
- Observe all applicable national and regional reg-
ulations and instructions during installation.
- The appliance is not approved for outdoor
installation.
- Observe the minimum clearances (see chap-
ter "Installation/ Preparations/ Siting the
appliance").
- Observe the requirements concerning the instal-
lation room (see chapter "Specification/ Data
table").
- If the appliance is permanently connected to the
power supply, ensure that the appliance can be
separated from the power supply by an isolator
that disconnects omnipolar with at least 3mm
contact separation. Contactors, mains isolators or
fuses can be used for this.
- Observe the safety measures to prevent contact
with dangerous 'live' currents.
- Observe the MCB/fuse protection required for
the appliance (see chapter "Specification/ Data
table").
- The power cable must only be replaced (for ex-
ample if damaged) with an original spare part by
a qualified contractor authorised by the manufac-
turer (connection typeX).
- The appliance is pressurised. During the heat-up
process, expansion water will drip from the safety
valve.
- Regularly activate the safety valve to prevent
it from becoming blocked, e.g. by limescale
deposits.
- Drain the appliance as described in chapter "In-
stallation/ Maintenance and cleaning/ Draining
the cylinder".
- Install a type-tested safety valve in the cold water
supply line.
- The maximum pressure in the cold water supply
line must be at least 20% below the response
pressure of the safety valve. If the maximum
pressure in the cold water supply line is higher,
install a pressure reducing valve.
- Size the drain so that water can drain off unim-
peded when the safety valve is fully opened.
- Fit the discharge pipe of the safety valve with
a constant downward slope and in a room free
from the risk of frost.
- The safety valve discharge aperture must remain
open to atmosphere.
314104-38523-9034_WWK_220-300_electronic_en_pl.indb 3 24.02.2015 10:33:15