STIEBEL ELTRON WWK 300 A - Standardised Output Data; Standard: EN 255-3

2
Contents
1. Operating instructions for users
and contractors ____________________ 3
1.1 Operation and control �������������� 3
1.2 Device description ������������������ 3
1.3 Correct operation ������������������� 3
1.4 Incorrect operation ����������������� 3
1.5 Function description ���������������� 3
1.6 Operation with active defrost fea-
ture
WWK 300 A and WWK 300 AH ���� 3
1.7 Maintenance and cleaning �������� 4
1.8 Troubleshooting by the user ������ 4
2. Installation instructions for con-
tractors _____________________________ 5
2.1 Regulations and standards �������� 5
2.2 Installation ��������������������������� 6
2.3 Water connection ������������������� 6
2.4 Power supply ������������������������ 8
2.5 Commissioning ���������������������� 8
2.6 Safety equipment and mainte-
nance ���������������������������������� 8
2.7 Specification ������������������������ 10
2.8 Operation with active defrost fea-
ture �����������������������������������11
2.9 Wiring diagrams ������������������� 12
2.10 Dimensions and connections ���� 14
Guarantee __________________________________15
Environment and Recycling ______________15
Note: Carefully read these
operating and installation
instructions and keep them safe. Should
the equipment change hands, pass these
instructions to the subsequent owner.
Pass them to the trained contractors for
servicing purposes.
Positioning, installation and commission-
ing must be carried out by trained per-
sonnel working in accordance with these
operating and installation instructions.
!
The appliance may be used by
children aged 8 and up and per-
sons with reduced physical, sensory or
mental capabilities or a lack of experi-
ence provided that they are supervised
or they have been instructed on how
to use the appliance safely and have
understood the resulting risks. Children
must never play with the appliance.
Children must never clean the appliance
or perform user maintenance unless
they are supervised.
Note: All measurements are given
in mm unless stated otherwise.
Standardised output data
Explanations to determine and interpret
the specified standardised output data
Standard: EN255-3
The output data specifically mentioned in
text, diagrams and technical datasheets
has been determined in line with the
test conditions described in the standard
shown in the heading of this chapter.
Generally, these standardised test condi-
tions will not fully meet the conditions
found at the installation site of the system
user. Depending on the chosen test meth-
od and the extent to which the selected
method deviates from the conditions
described in the standard shown in the
heading of this chapter, any deviations
can have a considerable impact. Further
factors that have an influence on the test
values are the measuring equipment, the
system configuration, the age of the sys-
tem and the flow rates.
A confirmation of the specified output
data can only be obtained if the condi-
tions applicable to the relevant test match
those of the standad shown in the head-
ing of this chapter.
Symbols used in these instructions
Observe the following safety instructions:
!
Please note: Warning about pos-
sible dangers.
Note: Important information and
tips.