EN - 12
6.
pulling out the bar, until the tree falls.
7.
bending the toothed chain, stop cutting
8.
6.4.2.c Limbing tree branches
Be careful of where the branches are
lying on the ground, the risk of them being
under tension, the direction the branch may
go during cutting and the risk of the tree
being unstable after the branch has been cut.
6.4.2.d Bucking the trunk
1.
2.
•
•
•
•
6.5 ADVICE FOR OPERATION
NOTE Avoid using the machine at full
power for the rst 6- 8 working hours.
IMPORTANT Stop the machine (par.
6.6) when moving between work areas.
6.6 STOP
1. Release the throttle trigger lever (Fig.
2.
to the «O» position.
3.
When you have reduced speed
to a minimum, it will take a few
seconds for the chain to stop.
The engine may be very warm
immediately after it is shut o. Do not
touch. The engine can cause burn injuries.
To Next Page
Loading...
Need help?
General
