28
User’s manual
EN
ROBOT CLEANING
1. Stop the robot safely (see “Robot Safety Stop”).
Warning – Caution
Use protective gloves to prevent cutting your hands.
2. Clean all the outside surfaces of the robot with a sponge soaked in warm water and a mild detergent. Squeeze well to remove
any excess water before use.
Warning – Caution
The use of too much water may cause water to penetrate into the device which could damage the electrical
parts.
3. Do not use solvents or benzene so as not to damage the painted surfaces and plastic components.
4. Do not wash the inside parts of the robot and do not use jets of pressurised water so as not to damage the
electric and electronic parts.
Warning – Caution
In order to avoid irreversible damage to the electric and electronic components, do not immerse the robot,
partially or completely, in water because it is not watertight.
5. Check the lower part of the robot (cutting blade area, and
wheels), use a brush suitable to remove deposits and/or
residues that may impede the proper functioning of the robot.
6. Remove any grass and leaves from the gripping areas of the
robot.
7. Clean the knobs of the battery charger (A), the contact plates
(B) and remove any deposits or residuals caused by electric
contacts with a dry cloth and, if necessary, with ne sandpaper.
8. Clean the rain sensor (C) and remove any dirt or rust.
9. Clean the inside of the charging station to remove any
accumulated residuals.
charging knobs (A)
contact plates (B)
rain sensor (C)
To Next Page
Loading...
Need help?
General
